在Ubuntu Linux下制作Windows 启动安装 USB盘

sudo fdisk /dev/sdb
Command (m for help): n
Partition type:
p primary ( primary, extended, free)
e extended
Select (default p): p
Partition number (-, default ):
Using default value
First sector (-, default ):
Using default value
Last sector, +sectors or +size{K,M,G} (-, default ):
Using default value Command (m for help): pDisk /dev/sdb: MB, bytes
heads, sectors/track, cylinders, total sectors
Units = sectors of * = bytes
Sector size (logical/physical): bytes / bytes
I/O size (minimum/optimal): bytes / bytes
Disk identifier: 0x8d55b9cb Device Boot Start End Blocks Id System
/dev/sdb1 Linux

Command (m for help): a
Partition number (-):
​
Command (m for help): pDisk /dev/sdb: MB, bytes
heads, sectors/track, cylinders, total sectors
Units = sectors of * = bytes
Sector size (logical/physical): bytes / bytes
I/O size (minimum/optimal): bytes / bytes
Disk identifier: 0x8d55b9cb Device Boot Start End Blocks Id System
/dev/sdb1 * Linux

Command (m for help): w
The partition table has been altered!

Calling ioctl() to re-read partition table.

WARNING: Re-reading the partition table failed with error 22: Invalid argument.
The kernel still uses the old table. The new table will be used at
the next reboot or after you run partprobe(8) or kpartx(8)
Syncing disks.

sudo mkfs -t ntfs /dev/sdb1

# 把下载的iso文件刻录到usb的分区中（及得，一定是分区，否则下次用这个usb是会出现 Operating not found的问题
sudo dd if=/home/peter/Downloads/WindowsTechnicalPreview-x64-ZH-CN.iso of=/dev/sdb1 bs=4M iflag=direct​

sudo apt-get install lilo
sudo lilo -M /dev/sdb mbr